805-929-0700

Repair and Maintenance IDIQ for NASA

Client: NASA

Description

This contract is for the repair, additions, alterations, and maintenance of commercial and institutional buildings including various mechanical systems (general construction, HVAC, plumbing and electrical) for Dryden Flight Research Center and Dryden Aircraft Operations Facility, Edwards AFB, Calif.

Scope of Work

Projects awarded to date have included the following scopes of work:

  • Correct Electrical Switching
    • Install switches to control lighting at six buildings where lighting circuits were controlled manually by switching the circuit breakers
    • Seven panelboards and 33 circuits were included in this project
  • Provide Power for Vibration Table Power Amplifier
    • Install an electrical service to a new vibration table power amplifier
  • Parking lot striping
    • Black out existing striping
    • Layout and stripe new spaces and driving lanes
  • Replace Air Receiver in Compressor Room -Bldg 703
    • Replace existing air receiver with a new one
    • Inspect system for leaks
  • Repair Substation #5
    • High-voltage cable replacement
    • New electrical equipment at the substation
  • Centerwide – Enable Electrical Metering System
    • Refurbish and install an advanced electrical metering system to monitor and report electricity consumption
  • Rooftop Exhaust Fan Fire Detection Interface
    • Install smoke detection control and notification system in 16 locations
  • Bldg. 703 4th Floor Lighting
    • Install new 480/277V 3 phase 4 wire 150 amp panelboard
    • Modify existing switching
    • Install 87 fluorescent lap fixtures with motion sensors
  • CITC Second Floor Bldg. 4838
    • Remodel second floor including demolition and installation of new walls, t-bar ceiling, HVAC controls and wiring, electrical, raised floor, carpeting, fire alarm and roof repair

On these task orders, T. Simons Co., Inc. self-performed the following:

  • Supervision
  • Quality Control
  • Safety management including traffic control, spotting and foreign object detection specifically for airfield operations areas

« Back to All Projects